Please Note:
Throughout this site we make reference to Connectable Areas, Dimensions, Pipe Sizes, Flow Rates and Rainfall Intensities. These by necessity vary, world wide. If you are interested in any product with such a specification, please either contact the 3P Partner in your country for the full Specification and/or for general Export Enquiries, please contact us for an immediate response. Thank you for your assistance.
> Products > Components > Wall Penetration Article No. 5000300

Description

Wall penetrations are sealing circuits.

According to the application, there are different wall penetrations available.

Normally Ø 32 for 1" PE-pipe,
Ø 36 for 1" hose,
Ø 50 for 50 HT-pipes for the supply of potable water.
Cable for power supply of submersible pump and for measuring the water level Ø16 for the PE-pipe of the backwashing device.

A wall penetration consists of a 30 mm strong rubber sheet with 2 discs and screw connections made of stainless steel.

How it works

Circuits and cables are pulled through the corresponding openings. Then the wall penetration is being fitted in the end of the empty conduit. The srew nuts are pointing outwards.

The srew nuts are tightened, therefore the two discs of stainless steel are pressing the rubber seals against the wall of the empty conduit therefore sealing the connection waterproof.